XLPE Insulated Power Cable
XLPE Insulated Power Cable
STANDARD:IEC 60840 AS/NZS1429.2 VDE 0276-632 VOLTAGE:up to 110kV CAPACITY:2000km/month good electrical, mechanical and thermal characteristics excellent moisture, chemical and weather resistant low dielectric factor than PVC insulation and better dielectric constant constant performance at a long temperature range long service span LV:IEC60502-1 ,VDE 0276-603, ICEA S-95-658 ,AS/NZS 5000.1 MV:IEC60502-2 ,VDE 0276-620 ,AS/NZS1429.1 ,ICEA S93-639 ,ICEA S94-649 HV:IEC 60840 ,AS/NZS1429.2 ,VDE 0276-632 Conductor Copper or aluminum, round, multiwire stranded and compact Inner semi-conducting layer Semi-conducting compound, cross-linked, Insulation Cross-linked polyethylene (XLPE), compound type Outer semi-conducting layer Semi-conducting compound, cross-linked, Concentricity of conductor The difference between the maximum and minimum value of 0,5 mm should not be exceeded. Semi-conducting type Over the outer semi-conducting layer, a semi-conducting tape must be used. Screen Screening of copper wires must have a minimum diameter of 0,5 mm and over that a copper tape applied helically with a minimum thickness of 0,1 mm. Separator Over the screen as well as under outer jacket, a separating layer must be used (e.g. taping). Outer jacket PE compound or PVC compound Suitable for installation mostly for power supply stations, in indoors and in cable ducts, outdoors, underground and in water as well as for installation on cable trays for industries, switch-boards and power stations. Due to the good laying characteristic, this can also be laid easilyin difficult line guideways.
Send Enquiry
