Medium Voltage Fill Shield Power Cable
Medium Voltage Fill Shield Power Cable
Conductor: Solid or Class B compressed concentric lay stranded 1350 aluminum meeting the requirements of ANSI/ICEA S-97-682. Conductor Shield: Extruded semi-conducting thermosetting polymeric stress control layer. Insulation: Extruded Ethylene Propylene Rubber (EPR) Class II and III as defined in ANSI/ICEA S-97-682. Insulation Shield: Extruded semi-conducting thermosetting layer, clean and free stripping from insulation. Copper Wire Shield: Helically applied annealed solid bare copper wires with a lapped non-metallic tape serving as a binder/separator. Jacket: Black, non-conducting, sunlight-resistant (PVC) or LLDPE. Triple-extruded for clean interfaces Flexibility for easy handling Excellent moisture resistance Deformation-resistant Sunlight-resistant High dielectric strength Low dielectric loss Excellent resistance to water treeing Clean-stripping insulation shield without the use of a release agent Standard: ANSI/ ICEA S-97-682 and AEIC CS8 Medium Voltage Fill Shield Power Cables are intended for use in dry or wet locations for distribution of three-phase medium-voltage power. Because it's filled with shield, these medium voltage cables may be installed in ducts or direct buried.
Send Enquiry
