Micro Hardness Tester with Computer
Micro Hardness Tester with Computer
Specifications:
Test force |
10g (0.098N), 25g (0.245N), 50g (0.49N), 100g (0.98N), 200g (1.96N), 300g (2.94N), 500g (4.9N), 1000g (9.8N) |
Rulers |
HV0.01, HV0.025, HV0.05, HV0.1, HV0.2, HV0.3, HV0.5, HV1, HV2 |
Minimum measurement unit |
0.25μm |
Measuring the hardness range |
1HV-4000HV |
Hardness value read |
Digital LCD |
Total magnification |
100X (observed), 400X (measurement) (Expandable up to 200X or 600X) |
Loading mode |
Fully automatic (loading, dwell, unloading) |
Holding Time |
1-99 seconds |
The objective lens and the press head switch |
The manual transfer Taqie change |
Specimen allows a maximum height |
85mm |
Indenter center to wall distance |
110mm |
Instrument Size |
405 × 290 × 480mm (L × W × H) |
Instrument Weight |
45kg |
Light source |
LED cold light source (continuous 24-hour use life of up to 100,000 hours) |
Power supply |
110V/220V + 5%, 50/60 Hz |
XY table |
Dimensions: 100 × 100 mm, the largest mobile: 25 × 25mm Minimum reading: 0.01mm (Optional digital XY table, LCD digital display) |
Data Output |
Built-in printer (hardness values, maximum and minimum test time, the number of tests, the average) Built-in RS-232 interface |
Implementation of standards |
GB/T4340.2 national standards, JJG151 VRof |
Standard fittings, accessories |
10X eyepiece micrometer a Vickers indenter a 10X and 40X objective lens of each one, and two standard hardness block, XY table, flat fixture, sheet fixtures, small parts jig a leveling screw four a bubble level, the power cord is a dust cover a manual, hardness conversion tables, certificate, warranty card, accessory case a |
Optional |
Image analysis software, metallurgical equipment, Knoop indenter Knoop hardness block, 15X eyepiece micrometer, 2.5X objective lens, 20X objective lens, 60X objective lens |
Send Enquiry