Corrosion Test Chamber

ENVIRONMENT TEST CONDITIONS:

Environment temperature range: 15 ~ 60
Relative humidity: Less than 85%R.H.
Atmosphere: 86 ~ 106 Kpa
Without strong vibration around
Without strong electromagnetic field around the influence, no high concentration of dust and corrosive materials
Avoid direct sunlight or other heat source direct radiation
Without strong airflow around, when the surrounding air should be forced to flow, flow should not blows directly to the body
Machine should be placed flat, maintain the level, because the upper water seal to prevent salt fog spillover
Around the machine there shall be a certain distance, convenient maintenance operation

MACHINE INTERNAL:

Spray tower (or baffle type): Invisible glass shower nozzle in nozzle interior, spray by tower tube guidance, then through conical disperser (or baffle) evenly dispersed spray to the laboratory internal.
Spray regulator: Adjust spray amount, adjustable high spray on the conical disperser (or baffle) spray quantity increase, the lower the spray to decrease, brine preheater tank, located in spray bottom department, the tank brine is the brine added box injection preheating tank, the water level of preheating tank by floating ball control, automatic control level, the groove bottom have for washing port, port by silica gel plug control.
Collector: Nozzle have eruptive fall fog quantity to free-fall way down to 80 cm of the funnel cup inside, again by duct flow to measuring cup inside.
Shelf: The shelves of window of model steel is made, pool weight can't more than 2 kg, if place dispersedly samples, affordable 10 kg weight within the supporter and lined with two rows round hole, round hole is for placing buy object bar, vertical plane is divided into 15 degrees and 30 degrees.
Heating water tanker: This tank adherent to the laboratory bottom, used to hold water humidifying keep laboratory temperature smooth, have added wet and heat preservation function.

MACHINE EXTERNAL:

Measuring pail: It collects the spray quantity, the highest scale is 50ml.
Insulated tank: Use water principle, avoid salt fog were leaked.
Saturated air barrel: Placed in control bottom part, USES the SUS304 stainless steel plate is made, its function lies in the air after the barrel warming humidification, allowing air to saturated humidity to the nozzle spray.
Test cover: Roof type bevel 100 degrees perspective cover, and used to cover in the laboratory, combined as one body.
Pressure regulating valve: Manual regulation inlet pressure and spray pressure inlet pressure control in 0.4 MPa, the spray pressure control in 0.07 ~ 0.17 MPa.
Pressure meter: This table pointer shows pressure is air after saturated air barrel heating, communicate spray or reach pressure.
Exhaust pipe: 1/2 diameter pipeline, combining drain to drain, make its wastewater which ruled out.
Water inlet: Supplementary laboratory and saturation bucket of water to normal usage.